D-Link DXS-3600 Series Reference Manual page 849

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on or turn off the OSPF redistribution debug switch. When one route of other
protocol is redistributed into OSPF or not redistributed into OSPF any more, the debug information will
print if the OSPF debug function is turned on.
Example
This example shows how to turn on the OSPF redistribution debug switch.
Switch# debug ip ospf redistribution
Switch#
Import AS external route from src 5 net 192.1.1.1
fwd 10.1.1.100 tic 500
71-51 debug ip ospf show counter
This command is used to display OSPF statistic counters.
debug ip ospf show counter [packet | neighbor | spf]
Parameters
packet
neighbor
spf
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to check statistic information about OSPF packet, neighbor and SPF calculations.
Example
This example shows how to displays all OSPF statistic counters.
Switch# debug ip ospf show counter
OSPF Debug Statistic Counters
Packet Receiving:
Total : 5
Hello : 5
DD : 0
LSR : 0
Specifies to displays the OSPF packet counter.
Specifies to displays the OSPF neighbor counter.
Specifies to displays the OSPF SPF event counter.
849
mask 255.255.255.0 type 2 cost 50