Show Ip Bgp Dampening Parameters - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Network
From
Flaps
Duration
Reuse
Path
10-83

show ip bgp dampening parameters

This command is used to display BGP dampening configurations.
show ip bgp [ipv4 unicast | vpnv4 vrf VRF-NAME}] dampening parameters
Parameters
ipv4
vpnv4
unicast
vrf VRF-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display BPG dampening related setting. If no option is specified for the command,
the information for IPv4 unicast address family will be displayed.
Example
This example shows how to display the dampening configuration information for the IPv4 unicast address
family.
Switch# show ip bgp dampening parameters
BGP Dampening for IPv4 Unicast
------------------------------------------
BGP Dampening State
BGP Dampening Route Map
Half-life Time
Reuse Value
Suppress Value
? - Origin of the path is not clear.
The IP address of a network entity.
The IP address of the peer that advertised this path.
The number of times the route has flapped.
The time since the router noticed the first flap.
The time after which the path will be made available.
The autonomous system path of the route that is being dampened.
(Optional) Specifies to display setting for the IPv4 address.
(Optional) Specifies to display setting for the VPNv4 address family.
Specifies to display setting for the unicast address family.
Specify to display setting for the VRF address family.
: Enabled
:
: 15 mins
: 750
: 2000
220