D-Link DXS-3600 Series Reference Manual page 504

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to enable the destination MAC address triggered update function.
Switch# configure terminal
Switch(config)# mac-address-table aging destination-hit
Switch(config)#
40-4 mac-address-table learning
This command is used to enable MAC address learning on the physical port. Use the no form of the
command to disable learning.
mac-address-table learning interface INTERFACE-ID [, | -]
no mac-address-table learning interface INTERFACE-ID [, | -]
Parameters
INTERFACE-ID
,
-
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this commands to enable or disable MAC address learning on a physical port.
Example
This example shows how to enable the MAC address learning option.
Switch# configure terminal
Switch(config)# mac-address-table learning interface eth1/0/5
Switch(config)#
40-5 mac-address-table notification change
This command is used to enable or configure the MAC address notification function. Use the no form of
the command to disable the function or set the optional configuration to default.
mac-address-table notification change [interval SECONDS | history-size VALUE]
(Optional) Specifies the physical port interface to be configured.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
504