D-Link DXS-3600 Series Reference Manual page 190

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
out
Default
None.
Command Mode
Router Configuration Mode.
Address Family Configuration (IPv4 unicast, VPNv4 and VRF) Mode.
Command Default Level
Level: 12.
Usage Guideline
The neighbor route-map command can be specified per address family. When specified in the router
configuration mode, the route map is applied to the IPv4 unicast address family only.
The user can specify one route map per address family for outbound routes to a BGP neighbor and one
route map for inbound routes from a BGP neighbor.
Example
This example shows how to apply a route map named internal-map to a BGP outgoing route from
172.16.70.24.
Switch# configure terminal
Switch(config)# router bgp 5
Switch(config)# neighbor 172.16.70.24 route-map internal-map out
Switch(config)# route-map internal-map
Switch(config-route-map)# match as-path 1
Switch(config-route-map)# set local-preference 100
Switch(config-route-map)#
10-54 neighbor route-reflector-client
This command is used to configure the router as a BGP route reflector and assign the specified neighbor
as its client. Use the no form of this command to remove the neighbor from the client list.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} route-reflector-client
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} route-reflector-client
Parameters
IP-ADDRESS
PEER-GROUP-NAME
Default
No route reflector client is configured.
Command Mode
Router Configuration Mode.
Address Family Configuration (IPv4 unicast and VPNv4) Mode.
Specifies that the route map is applied to the paths advertised to the
neighbor.
Specifies the IP address of the neighboring router.
Specifies the peer group to act as the route reflector client.
190