D-Link DXS-3600 Series Reference Manual page 140

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
The default value advertised in RA is 0.
The default value used by the router is 1000 (one second).
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The configured time is used by the router on the interface and is also advertised in the RA message. If
the specified time is 0, the router will use 1 second on the interface and advertise 0 (unspecified) in the
RA message.
Example
This example shows how to configure the IPv6 NS message retransmission interval to 6 seconds.
Switch# configure terminal
Switch(config)# interface vlan1
Switch (config-if)# ipv6 nd ns-interval 6000
Switch (config-if)#
9-17 ipv6 neighbor
This command is used to create a static ipv6 neighbor entry. Use the no form of this command to delete a
static IPv6 neighbor entry.
ipv6 neighbor IPV6-ADDRESS INTERFACE-ID MAC-ADDRESS
no ipv6 neighbor IPV6-ADDRESS INTERFACE-ID
Parameters
IPV6-ADDRESS
INTERFACE-ID
MAC-ADDRESS
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
in milliseconds. This value must be between 0 and 3600000
milliseconds, in multiples of 1000.
Specifies the IPv6 address of the IPv6 neighbor cache entry.
Specifies the interface for creating the static IPv6 neighbor cache
entry.
Specifies the MAC address of the IPv6 neighbor cache entry.
140