D-Link DXS-3600 Series Reference Manual page 687

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command on the destination switch of an RSPAN session.
The monitor session source remote vlan command configures the VLAN that the monitored source
packets are tunneled to the switch from the remote site. Use the monitor session destination interface
command to configure the destination port to transmit the monitored packet.
Each session should be configured with a unique RSPAN VLAN. Use the remote-span command in the
VLAN configuration mode to specify a VLAN as an RSPAN VLAN.
Example
This example shows how to create an RSPAN session on the destination switch. It assigns VLAN 100 as
the RSPAN VLAN and ethernet1/0/4 as the destination port. It also assigns VLAN 100 as the RSPAN
VLAN. The monitored packets arrive at port ethernet2/0/1 and will be transmitted out from port
ethernet1/0/4.
Switch# configure terminal
Switch(config)# vlan 100
Switch(config-vlan)# remote-span
Switch(config-vlan)# exit
Switch(config)# interface ethernet2/0/1
Switch(config-if)# switchport mode trunk
Switch(config-if)# switchport trunk allowed vlan 100
Switch(config-if)# exit
Switch(config)# interface ethernet1/0/4
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 100
Switch(config-if)# exit
Switch(config)# monitor session 2 source remote vlan 100
Switch(config)# monitor session 2 destination interface ethernet1/0/4
Switch(config)#
61-6 remote-span
This command is used to specify a VLAN as an RSPAN VLAN. Use the no form of the command to revert
to a non-RSPAN VLAN.
remote-span
no remote-span
Parameters
None.
Default
None.
Command Mode
687