D-Link DXS-3600 Series Reference Manual page 237

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
10-98 synchronization
This command is used to enable the advertisement of a route to an external neighbor by the BGP
speaker unless the route is a local router or the BGP speaker has learned the route by IGP. Use the no
form of this command to disable the option.
synchronization
no synchronization
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When synchronization is enabled, the BGP speaker will not advertise a route to an external neighbor
unless the route is a local route or the BGP speaker has learned the route by IGP.
Example
This example shows how to enable synchronization for the BGP process.
Switch# configure terminal
Switch(config)# router bgp 65121
Switch(config-router)# synchronization
Switch(config-router)#
10-99 timers bgp
This command is used to configure BGP network timers. Use the no form of this command to restore the
default setting.
timers bgp KEEP-ALIVE HOLD-TIME
no timers bgp
Parameters
KEEP-ALIVE
HOLD-TIME
Specifies the interval that the software sends keep-alive messages to
its BGP peer. The range is from 0 to 65535.
Specifies the length of the time-out value of the keep-alive message.
The software will declare a BGP peer dead after the timeout. The
range is from 0 to 65535.
237