D-Link DXS-3600 Series Reference Manual page 176

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
IP-ADDRESS
PEER-GROUP-NAME
SECONDS
Default
By default, the interval value is 15 seconds.
Command Mode
Router Configuration Mode.
Address Family Configuration Mode (VRF).
Command Default Level
Level: 12.
Usage Guideline
AS origination routes can be generated by network, aggregate and redistribute commands. Use this
command to configure the minimum interval value when sending these routes.
Example
This example shows how to set the AS origination interval of 15.1.1.52 to 100.
Switch# configure terminal
Switch(config)# router bgp 65100
Switch(config-router=)# neighbor 15.1.1.52 as-origination-interval 100
10-38 neighbor as-override
This command is used to enable to override the AS number of a site with the provider's AS number on a
PE router. Use the no form of the command to disable this function.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} as-override
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} as-override
Parameters
IP-ADDRESS
PEER-GROUP-NAME
Default
By default, this option is disabled.
Command Mode
Address Family Configuration Mode (VRF).
Command Default Level
Level: 12.
Usage Guideline
Specifies the IP address of the neighbor peer.
Specifies the name of the BGP peer group.
Specifies the minimum interval, in seconds, between the sending of AS
origination routing update messages. This value must be between 1
and 600.
Specifies the IP address of the neighbor peer.
Specifies the name of the BGP peer group.
176