D-Link DXS-3600 Series Reference Manual page 345

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to configure the waiting time for a ping reply.
Switch# configure terminal
Switch(config)# ip dhcp ping timeout 800
Switch(config)#
21-17 ip dhcp pool (DHCP Server)
This command is used to configure a DHCP address pool on the DHCP server and enter the DHCP Pool
Configuration Mode. Use the no form of this command to remove a DHCP address pool.
ip dhcp pool NAME
no ip dhcp pool NAME
Parameters
NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A DHCP server receives requests from DHCP clients and services and then allocates an IP address from
the address pool and replies the address to the client. An address pool can either contain a network of IP
addresses or a single IP address. Use the network command in the DHCP Pool Configuration Mode to
specify a network for the address pool or use the client-identifier or hardware-address command with
the host command to specify a manual binding entry in a DHCP address pool.
Example
This example shows how a DHCP address pool "pool1" is created.
Switch# configure terminal
Switch(config)# ip dhcp pool pool1
Switch(config-dhcp-pool)#
21-18 ip dhcp use class (DHCP Relay & Server)
This command is used to specify the DHCP server to use DHCP classes during address allocation or the
DHCP relay agent to use DHCP classes to locate the relay destination addresses. Use the no command
to disable the use of DHCP classes.
ip dhcp use class
Specifies the name of the address. This name can be up to 32
characters long.
345