D-Link DXS-3600 Series Reference Manual page 167

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# clear ip bgp flap-statistics
Switch#
10-28 distance bgp
This command is used to configure the distance for BGP routes. Use the no form of the command to
restore to the default setting.
distance bgp EXTERNAL-DISTANCE INTERNAL-DISTANCE
no distance bgp
Parameters
EXTERNAL-DISTANCE
INTERNAL-DISTANCE
Default
External distance is 70.
Internal distance is 130.
Command Mode
Router Configuration Mode.
Address Family Configuration (VRF) Mode.
Command Default Level
Level: 12.
Usage Guideline
User can use the distance bgp command to set the administrative distance for routes learned from
eBGP peers and iBGP peers. The distance bgp command acts as the distance command for other
routing protocol, determines which routes will be installed in routing information base.
Numerically, an administrative distance is an integer from 1 to 999. In general, the higher the value is, the
lower the rating of trustworthiness is.
Example
This example shows how to set the distance of external routes and internal routes in to 50, 100,
respectively.
Switch# configure terminal
Switch(config)# router bgp 65100
Switch(config-router)# distance bgp 50 100
10-29 ip as-path access-list
This command is used to define a rule entry for a BGP Autonomous System (AS) path access list. Use
the no form of this command to remove the definition of an AS path access-list.
Specifies the distance for routes learned from external peers. The valid
range is 1 to 999.
Specifies the distance for routes learned from internal peers. The valid
range is 1 to 999.
167