D-Link DXS-3600 Series Reference Manual page 650

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to configure the LLDP MED fast start repeat count.
Switch# configure terminal
Switch(config)# lldp fast-count 10
Switch(config)#
58-7 lldp hold-multiplier
This command is used to configure the hold multiplier for LLDP updates on the switch. Use the no form of
this command to return to the default settings.
lldp hold-multiplier VALUE
no hold-multiplier
Parameters
VALUE
Default
By default, this value is 4.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This parameter is a multiplier on the LLDPDUs transmission interval that is used to compute the TTL
value in an LLDPDU. The lifetime is determined by the hold-multiplier times the TX-interval. At the partner
switch, when the TTL for a given advertisement expires, the advertised data is deleted from the neighbor
switch's MIB.
Example
This example shows how to configure the LLDP hold-multiplier to 3.
Switch# configure terminal
Switch(config)# lldp hold-multiplier 3
Switch(config)#
58-8 lldp management-address
This command is used to configure the management address that will be advertised on the physical
interface. Use the no form of this command to remove the settings.
lldp management-address [IP-ADDRESS | IPV6-ADDRESS]
no lldp management-address [IP-ADDRESS | IPV6-ADDRESS]
Specifies the multiplier on the LLDPDUs transmission interval that
used to compute the TTL value of an LLDPDU. This value must be
between 2 and 10.
650