D-Link DXS-3600 Series Reference Manual page 819

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
interface that has a subnet defined that belongs to the network specified, by this command, will be
activated.
Example
This example shows how to define the OSPF area 3 on interfaces with the IP address that starts with the
octet value of 10.
Switch# configure terminal
Switch(config)# router ospf 1
Switch(config-router)# network 10.0.0.0 255.0.0.0 area 3
Switch(config-router)#
71-20 no area
This command is used to remove the settings associated with an area.
no area AREA-ID
Parameters
AREA-ID
Default
None.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to remove the settings associated with an area. The area reverts to a normal area.
Example
This example shows how to clear all options associated with the area 3 and revert it to normal area.
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# no area 3
Switch(config-router)#
71-21 passive-interface
This command is used to disable the sending and receiving of the OSPF routing updates on an interface.
Use the no command to enable the sending and receiving of routing updates.
passive-interface {default | INTERFACE-ID}
no passive-interface {default | INTERFACE-ID}
Specifies the area ID.
819