D-Link DXS-3600 Series Reference Manual page 651

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
IP-ADDRESS
IPV6-ADDRESS
Default
No LLDP management address is configured (no Management Address TLV is sent).
Command Mode
Interface Configuration Mode.
Command Default Level
Level:12.
Usage Guideline
This command is available for physical port configuration. This command specifies the IPv4/IPv6 address
that is carried in the management address TLV on the specified port. If an IP address is specified, but the
address is not one of the addresses of the system interfaces, then the address will not be sent.
When no optional address is specified along with the command lldp management-address, the switch
will find least one IPv4 and IPv6 address of the VLAN with the smallest VLAN ID. If no applicable
IPv4/IPv6 address exists, then no management address TLV will be advertised. Once the administrator
configures an address, both of the default IPv4 and IPv6 management address will become inactive and
won't be sent. The default IPv4 or IPv6 address will be active again when all the configured addresses
are removed. Multiple IPv4/IPv6 management addresses can be configured by using this command
multiple times.
Use the no lldp management-address command without a management address to disable the
management address adverted in LLDPDUs. If there is no effective management address in the list, no
Management Address TLV will be sent.
Example
This example shows how to enable eth3/0/1 and eth3/0/2 for setting the management address entry
(IPv4).
Switch# configure terminal
Switch(config)# interface range eth3/0/1-3/0/2
Switch(config-if-range)# lldp management-address 10.1.1.1
Switch(config-if-range)#
This example shows how to enable eth3/0/3 and eth3/0/4 for setting the management address entry
(IPv6).
Switch# configure terminal
Switch(config)# interface range eth3/0/3-3/0/4
Switch(config-if-range)# lldp management-address FE80::250:A2FF:FEBF:A056
Switch(config-if-range)#
This example shows how to delete the management address 10.1.1.1 from eth3/0/1 and eth3/0/2. If
10.1.1.1 is the last one, no Management Address TLV will be sent.
Switch# configure terminal
Switch(config)# interface range eth3/0/1-3/0/2
Switch(config-if-range)# no lldp management-address 10.1.1.1
(Optional) Specifies the IPv4 address that is carried in the
management address TLV.
(Optional) Specifies the IPv6 address that is carried in the
management address TLV.
651