D-Link DXS-3600 Series Reference Manual page 408

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
++ : high alarm, +
mA: milliamperes, mW: milliwatts
A: The threshold is administratively configured.
eth2/0/3
Transceiver Monitoring is enabled
Transceiver Monitoring shutdown action：Alarm
Temperature(C)
Voltage (v)
Bias Current(mA)
TX Power (mW)
RX Power (mW)
Switch#
27-2 transceiver-monitoring action shutdown
This command is used to shut down a port from an alarm or a warning of an abnormal status.
Use the no form of the command to disable the shutdown action.
transceiver-monitoring action shutdown { alarm | warning}
no transceiver-monitoring action shutdown
Parameters
alarm
warning
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port interface configuration.
The configuration can select to shut down a port on an alarm event or warning event or not to shut down
on either of them. When the monitoring function is enabled, an alarm event occurs when the parameters,
being monitored, go higher than the high alarm threshold or go lower than the low alarm threshold. A
warning event occurs when the parameters being monitored go higher than the high warning threshold or
go lower than the low warning threshold.
The port shutdown feature is controlled by the Error Disable module without a recover timer. Users can
manually recover the port by using the shutdown command and then the no shutdown command.
Example
: high warning, - : low warning, -- : low alarm
Current High-Alarm
30.090 75.000(A)
3.353 3.630
16.794(++) 10.500
0.258 1.413
0.000(--) 1.585
Specifies to shut down a port when alarm events occur.
Specifies to shut down a port when warning events occur.
408
High-Warning Low-Warning Low-Alarm
70.000 0.000
3.465 3.135
9.000 2.500
0.708 0.186
0.794 0.102
-5.000
2.970
2.000
0.074
0.041