D-Link DXS-3600 Series Reference Manual page 389

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
ipv6 dhcp relay remote-id udf {ascii STRING | hex HEX-STRING}
Parameters
ascii STRING
hex HEX-STRING
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the UDF for the Remote ID.
Example
This example shows how to configure the UDF to the ASCII string "PARADISE001".
Switch# configure terminal
Switch(config)# ipv6 dhcp relay remote-id udf ascii PARADISE001
Switch(config)#
This example shows how to configure the UDF to the hexadecimal string "010c08".
Switch# configure terminal
Switch(config)# ipv6 dhcp relay remote-id udf hex 010c08
Switch(config)#
25-6 show ipv6 dhcp
This command is used to display the DHCPv6 related settings on the interface.
show ipv6 dhcp [interface [INTERFACE-ID]]
Parameters
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Specifies the ASCII string (a maximum of 128 characters) for the UDF
of the Remote ID.
Specifies the hexadecimal string (a maximum of 256 digits) for the
UDF of the Remote ID.
(Optional) Specifies the VLAN interface ID to display.
389