D-Link DXS-3600 Series Reference Manual page 199

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
NETWORK-NUMBER
SUBNET-LENGTH
route-map MAP-NAME
Default
None.
Command Mode
Router Configuration Mode.
Address Family Configuration (IPv4 unicast and VRF) Mode.
Command Default Level
Level: 12.
Usage Guideline
This command can be used to specify a network in the local AS. The network is added in the routing table,
and will be advertised to the external neighbor peer. BGP networks can be learned from connected routes,
from dynamic routing, and from static route sources.
Use this command to specify a network as local to this autonomous system and adds it to the BGP
routing table. For exterior protocols the network command controls which networks are advertised. Interior
protocols use the network command to determine where to send updates.
Example
This example shows how to set up network 10.108.0.0 to be included in the BGP updates for AS number
is 65100.
Switch# configure terminal
Switch(config)# router bgp 65100
Switch(config-router)# network 10.108.0.0/16
10-65 redistribute
This command is used to redistribute routes from one routing domain into BGP. Use the no command to
disable route redistribution.
redistribute {connected | static | rip | ospf {all | internal | external | type-1 | type-2 | inter+e1 |
inter+e2}} [metric METRIC-VALUE | route-map MAP-NAME]
no redistribute {local | static | rip | ospf} [metric | route-map]
Parameters
connected
static
rip
ospf
Specifies the network number that BGP will advertise.
Specifies the length of the network or sub-network.
(Optional) Specifies the identifier of a route map. The configured
network must be permitted by the specified route map to be
advertised.
Specifies to redistribute connected routes to BGP.
Specifies to redistribute static routes to BGP.
Specifies to redistribute RIP routes to BGP.
Specifies to redistribute OSPF routes to BGP.
all - Specifies to redistribute both OSPF AS-internal and OSPF AS-
199