D-Link DXS-3600 Series Reference Manual page 780

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch#
67-43 snmp-server enable traps mpls ldp
This command is used to enable the LDP trap state. Use the no form of this command to disable the LDP
trap state.
snmp-server enable traps mpls ldp
no snmp-server enable traps mpls ldp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command used to configure the LDP trap state.
Example
This example shows how to enable the LDP trap state.
Switch# configure terminal
Switch(config)# snmp-server enable traps mpls ldp
Switch(config)#
67-44 snmp-server enable traps mpls lsp
This command is used to enable the MPLS LSP trap state. Use the no form of this command to disable
the MPLS LSP trap state.
snmp-server enable traps mpls lsp
no snmp-server enable traps mpls lsp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
780