D-Link DXS-3600 Series Reference Manual page 574

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
1
2
3
Default
The default IGMP version is 3.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Different IGMP versions support different functions for multicast data routing to hosts. Some commands
are only effective for IGMPv2 and IGMPv3.For example, if you change to version 1, then the setting
configured by the ip igmp query-max-response-time command will not be effective.
Example
This example shows how to configure the IGMP version to 3.
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ip igmp enable
Switch(config-if)# ip igmp version 3
Switch(config-if)#
46-12 show ip igmp groups
This command is used to display IGMP group information on an interface.
show ip igmp groups [IP-ADDRESS | interface INTERFACE-ID] [{detail | static}]
Parameters
IP-ADDRESS
interface INTERFACE-ID
detail
static
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Specifies to configure the switch to run IGMP version 1.
Specifies to configure the switch to run IGMP version 2.
Specifies to configure the switch to run IGMP version 3.
(Optional) Specifies Group IP address to be displayed. If no IP address
is specified, all IGMP group information will be displayed.
(Optional) Specifies the interface to be displayed. If no interface is
specified, IGMP group information for all interfaces that are IGMP
enabled will be displayed.
(Optional) Specifies to display detailed information.
(Optional) Specifies to display the static group.
574