D-Link DXS-3600 Series Reference Manual page 132

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the interface to use DHCPv6 to get an IPv6 address. When the no ipv6
address dhcp command is used, the previous DHCPv6 obtained IP address will be removed. If the rapid
commit keyword is specified for the command, the rapid commit option will be included in the solicit
message to request for the two-message exchange for address delegation.
Example
This example shows how to configure VLAN 1 to use DHCPv6 to get an IPv6 address.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 address dhcp
Switch(config-if)#
9-6 ipv6 enable
This command is used to enable IPv6 processing on interfaces that have no IPv6 address explicitly
configured. Use the no form of the command to disable IPv6 processing on interfaces that have no IPv6
address explicitly configured.
ipv6 enable
no ipv6 enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the IPv6 address is explicitly configured on the interface, the IPv6 link-local address is
automatically generated and the IPv6 processing is started. When the interface has no IPv6 address
explicitly configured, the IPv6 link-local address is not generated and the IPv6 processing is not started.
Use the ipv6 enable command to auto-generate the IPv6 link-local address and start the IPv6 processing
on the interface.
Example
This example shows how to enable IPv6 on interface VLAN 1, which has no IPv6 address explicitly
configured.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 enable
132