D-Link DXS-3600 Series Reference Manual page 459

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The following two actions are allowed by ports in the active mode, but disallowed by ports in the passive
mode.
•
Initiate OAM discovery.
•
Start or stop remote loopback.
Example
This example shows how to configure interface eth1/0/1 Ethernet OAM mode to active.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# ethernet oam mode active
Switch(config-if)#
36-3 ethernet oam link-monitor error-symbol
This command is used to enable notifying the Ethernet OAM error symbol event and configure the
monitor threshold and window on the specified port. Use the no command to disable notifying the event
and return the parameters to default value.
ethernet oam link-monitor error-symbol [threshold NUMBER] [window DECISECONDS]
no ethernet oam link-monitor error-symbol [threshold] [window]
Parameters
threshold NUMBER
window DECISECONDS
Default
The Ethernet OAM error symbol event will be notified by default.
The default Ethernet OAM error symbol monitor threshold is 1.
The default Ethernet OAM error symbol monitor window is 10 deciseconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Specifies a number of symbol errors. If symbol errors occur in the
specified window and it exceeds the threshold value, then the event is
generated. The range is 0 to 4294967295.
Specifies the amount of time over which the threshold is defined. If
threshold symbol errors occur within the period, an event notification
OAM PDU should be generated with an error symbol period event
TLV, indicating that the threshold has been crossed in this window.
The range is 10 to 600 deciseconds.
459