Show Ipv6 Mld Groups - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ipv6 mld version 1
Switch(config-if)#

64-8 show ipv6 mld groups

This command is used to display MLD group information on an interface.
show ipv6 mld groups [GROUP-ADDRESS | interface INTERFACE-ID] [detail]
Parameters
GROUP-ADDRESS
interface INTERFACE-ID
detail
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display multicast group information for a specific group or for a specific interface.
Example
This example shows how to display MLD group information in interface VLAN 1.
Switch#show ipv6 mld groups interface vlan1
Group Address
-------------------------------------------------------------------
FF02::1:FF00:65
FF02::1:FF23:86CC
FF02::4:FF00:1
Total Entries: 3
Switch#
This example shows how to display MLD group detailed information of group ff02::1:ff23:86cc.
Switch# show ipv6 mld groups ff02::1:ff23:86cc detail
Interface
Group
(optional) Specifies to display the group IPv6 address. If no IPv6
address specified, all MLD group information will be displayed.
(optional) Specifies the interface to display. If no interface is specified,
MLD group information about all interfaces will be displayed.
(Optional) Specifies to display the detailed group information.
: vlan1
: FF02::1:FF23:86CC
Interface Uptime
vlan1 0DT00H05M26S 0DT00H01M12S
vlan1 0DT00H03M26S 0DT00H01M55S
vlan1 0DT00H04M12S Stopped
719
Expire