D-Link DXS-3600 Series Reference Manual page 652

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-if-range)#
This example shows how to delete the management address FE80::250:A2FF:FEBF:A056 from eth3/0/3.
and eth3/0/4.
Switch# configure terminal
Switch(config)# interface range eth3/0/3-3/0/4
Switch(config-if-range)# no lldp management-address FE80::250:A2FF:FEBF:A056
Switch(config-if-range)#
This example shows how to delete all management addresses from eth3/0/5 and then no Management
Address TLV will be sent on eth3/0/5.
Switch# configure terminal
Switch(config)# interface eth3/0/5
Switch(config-if)# no lldp management-address
Switch(config-if)#
58-9 lldp med-tlv-select
This command is used to specify which optional LLDP-MED TLV will be transmitted and encapsulated in
the LLDPDUs and sent to neighbor devices. To disable the transmission of the TLVs, use the no form of
this command.
lldp med-tlv-select [capabilities | inventory-management]
no lldp med-tlv-select [capabilities | inventory-management]
Parameters
capabilities
inventory-management
Default
No LLDP-MED TLV is selected.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to enable or disable
transmitting LLDP-MED TLVs.
When disabling the transmission of the Capabilities TLV, LLDP-MED on the physical interface will be
disabled at the same time. In other words, all LLDP-MED TLVs will not be sent, even when other LLDP-
MED TLVs are enabled to transmit.
By default, the switch only sends LLDP packets until it receives LLDP-MED packets from the end device.
The switch continues to send LLDP-MED packets until it only receives LLDP packets.
(Optional) Specifies to transmit the LLDP-MED capabilities TLV.
(Optional) Specifies to transmit the LLDP-MED inventory management
TLV.
652