Show Ipv6 Pim Neighbor - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
78-21

show ipv6 pim neighbor

This command is used to display PIM neighbor information.
show ipv6 pim neighbor sparse-mode [detail] [INTERFACE-ID]
Parameters
detail
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to determine which routers on the LAN are configured for PIMv6.
Example
This example shows how to display the sparse-mode neighbor information.
Switch# show ipv6 pim neighbor sparse-mode
Mode: B - Bidir Capable, DR - Designated Router, N - Default DR Priority,
G - Supports Generation ID
Neighbor-Address Interface Uptime/Expires Ver DR Pri/Mode
------------------------------------------------------------------------------
fe80::a01:2ff:fe39:1
fe80::a01:2ff:fe39:2
Total Entries: 2
Switch#
Display Parameters
Neighbor-Address
Interface
Uptime
Expires
(Optional) Specifies to display IPv6 PIM neighbor information in detail.
(Optional) Specifies the interface of which to display the PIM neighbor
information. If the interface ID is not specified, the information on all
interfaces will be displayed.
vlan1 0DT00H55M33S/0DT00H01M32S v2 1 /G
vlan2 0DT00H55M30S/0DT00H01M20S v2 1 /DR,G
The IPv6 address of the PIM neighbor (link-local address).
The neighbor's interface name.
The length of time that the router has known about this neighbor.
The time after which the information about this neighbor expires. If the
router does not receive any hello messages in this time, it will discard
information about this neighbor.
928