D-Link DXS-3600 Series Reference Manual page 820

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
INTERFACE-ID
default
Default
OSPF routing update packets are sent and received on the interface.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If an interface is passive, the OSPF routing update packets are not sent nor received through the
specified interface.
Example
This example shows how to configure the interface VLAN 1 to the passive mode.
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)# passive-interface vlan1
Switch(config-router)#
71-22 redistribute
This command is used to redistribute routes from one routing domain into another routing domain. Use
the no command to disable redistribution.
redistribute PROTOCOL [metric METRIC-VALUE] [metric-type TYPE-VALUE] [route-map MAP-
NAME]
no redistribute PROTOCOL [metric] [metric-type] [route-map]
Parameters
PROTOCOL
metric METRIC-VALUE
metric-type TYPE-VALUE
Specifies the routing interface.
(Optional) Specifies the default state of a routing interface when its
state is not individually specified.
Specifies the source protocol from which routes are being
redistributed. It can be one of the following keywords: bgp,
connected, ospf, static, or rip. For routing protocols such as Open
Shortest Path First (OSPF), these routes will be redistributed as
external to the autonomous system.
(Optional) Specifies a metric for the redistributed routes. The valid
value is from 0 to 16777214.
(Optional) Specifies the external link type of the route being
redistributed into the OSPF routing domain. It can be one of two
values:
1: Specifies to use the Type-1 external route.
2: Specifies to use the Type-2 external route.
If a metric type is not specified, the switch will adopt a Type-2 external
820