D-Link DXS-3600 Series Reference Manual page 896

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)#
75-5 power-saving hibernation time-range
This command is used to configure the time range profile for the system hibernation schedule. Use the no
form of the command to delete the specified time range profile.
power-saving hibernation time-range PROFILE-NAME
no power-saving hibernation time-range PROFILE-NAME
Parameters
PROFILE-NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add or delete a time range profile for the system hibernation schedule. When the
system enters the hibernation mode, the switch will go into a low power state and idle. It will shut down all
the ports and LEDs, all network function will be disabled, and only the console connection will work via
the RS232 port. If the switch is an endpoint type Power Sourcing Equipment (PSE), the switch will not
provide power to the port.
Example
This example shows how to add a time range profile for the hibernation schedule.
Switch# configure terminal
Switch(config)# power-saving hibernation time-range off-duty
Switch(config)#
75-6 power-saving shutdown time-range
This command is used to configure the time range profile for the port shutdown schedule. Use the no
form of the command to delete the specified time range profile.
power-saving shutdown time-range PROFILE-NAME
no power-saving shutdown time-range PROFILE-NAME
Parameters
PROFILE-NAME
Specifies the name of the time range profile to be configured. The
maximum length is 32 characters.
Specifies the name of the time range profile to be configured. The
896