D-Link DXS-3600 Series Reference Manual page 236

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Use this command to display a specific extended community list or all configured extended community
lists.
Example
This example shows how to display all of the configured IP extended community lists.
Switch# show ip extcommunity-list
Expanded extended community list e1
permit : _23
Standard extended community list s1
permit : RT
SoO 1.1.1.1:1
permit : SoO 2:3 3.2.1.1:10
Total Entries: 2
Switch#
10-97 snmp-server enable traps bgp
This command is used to enable Border Gateway Protocol (BGP) support for Simple Network
Management Protocol (SNMP) operations. Use the no form of this command to disable it.
snmp-server enable traps bgp {established | backward-trans}
no snmp-server enable traps bgp {established | backward-trans}
Parameters
established
backward-trans
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the BGP trap state.
Example
This example shows how to enable the sending of the BGP peer established trap.
Switch# configure terminal
Switch(config)# snmp-server enable traps bgp established
Switch(config)#
1:1
Specifies to enable or disable the sending of the peer established trap.
Specifies to enable or disable the sending of the peer idle trap.
236