D-Link DXS-3600 Series Reference Manual page 662

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
INTERFACE-ID
,
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the LLDP information of each physical interface.
Example
This example shows how to display a specific physical interface's LLDP configuration.
Switch#show lldp interface ethernet 1/0/1
Port ID: eth1/0/1
------------------------------------------------------------------------------
Port ID
Admin Status
Notification
Basic Management TLVs:
Port Description
System Name
System Description
System Capabilities
Enabled Management Address:
(None)
IEEE 802.1 Organizationally Specific TLVs:
Port VLAN ID
Enabled Port_and_Protocol_VLAN_ID
1, 2, 3
Enabled VLAN Name
1-3
Enabled Protocol_Identity
EAPOL, LACP, GVRP, STP
IEEE 802.3 Organizationally Specific TLVs:
MAC/PHY Configuration/Status
Link Aggregation
Maximum Frame Size
Specifies to display the LLDP configuration for a specific interface.
Valid interfaces are physical interfaces.
(Optional) Specifies a series of physical interfaces. No spaces before
and after the comma.
(Optional) Specifies a range of physical interfaces. No spaces before
and after the hyphen.
662
:eth1/0/1
:TX and RX
:Disabled
:Enabled
:Enabled
:Enabled
:Enabled
:Enabled
:Enabled
:Disabled
:Disabled