Ipmcv6 Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

52. IPMCv6 Commands

52-1 ipv6 multicast-routing
This command is used to enable IPv6 multicast routing. Use the no form of this command to disable IPv6
multicast routing.
ipv6 multicast-routing
no ipv6 multicast-routing
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When IPv6 multicast routing is disabled, the system will stop routing multicast packets even though the
multicast routing protocol is enabled.
Example
This example shows how to enable IPv6 multicast routing.
Switch# configure terminal
Switch(Config)# ipv6 multicast-routing
Switch(Config)#
52-2 ipv6 mroute
This command is used to create a static IPv6 multicast route (mroute). Use the no form of this command
to delete the route.
ipv6 mroute IPV6-PREFIX/PREFIX-LENGTH {RPF-IPV6ADDRESS | INTERFACE-ID RPF-
IPV6ADDRESS | null}
no ipv6 mroute {IPV6-PREFIX/PREFIX-LENGTH | all}
Parameters
IPV6-PREFIX
PREFIX-LENGTH
Specifies the network address of the multicast source.
Specifies the prefix length for the multicast source. A decimal value
that indicates how many of the high-order contiguous bits of the
address comprise the prefix (the network portion of the address). A
slash mark must precede the decimal value.
610