D-Link DXS-3600 Series Reference Manual page 11

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
•
The command line console allows us to access the console interface's Line Configuration Mode.
•
The command login local tell the switch that users need to enter locally configured login
credentials to access the console interface.
Save the running configuration to the start-up configuration. This means to save the changes made so
that when the switch is rebooted, the configuration will not be lost. The following example shows how to
save the running configuration to the start-up configuration.
Switch#copy running-config startup-config
Destination filename startup-config? [y/n]:
Saving all configurations to NV-RAM.......... Done.
Switch#
After the switch was rebooted, or when the users logs out and back in, the newly created username and
password must be entered to access the CLI interface again, as seen below.
User Access Verification
Username:admin
Password:*****
Switch#
Interface Notation
When configuration the physical ports available on this switch, a specific interface notation is used. The
following will explain the layout, terminology and use of this notation.
In the following example, we'll enter the Global Configuration Mode and then enter the Interface
Configuration Mode, using the notation 1/0/1. After entering the Interface Configuration Mode for port 1,
we'll change the speed to 1 Gbps, using the speed 1000 command.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/1
Switch(config-if)# speed 1000
Switch(config-if)#
In the above example the notation 1/0/1 was used. The terminology for each parameter is as follows:
•
Interface Unit's ID / Open Slot's ID / Port's ID
DXS-3600-32S TenGigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.012
Copyright(C) 2013 D-Link Corporation. All rights reserved.
y
11