D-Link DXS-3600 Series Reference Manual page 417

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
The default metric value is 1.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
For each source network reported, a route metric is associated with the route being reported. The metric
is the sum of the interface metrics between the router originating the report and the source network. For
DVMRP, the metric with 32 means infinity (unreachable). This limits the breadth across the whole
DVMRP network and is necessary to place an upper bound on the convergence time of the protocol.
Example
This example shows how to change the metric value to 2 of an interface.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip dvmrp metric 2
28-3 ip dvmrp neighbor-timeout
This command is used to configure the DVMRP neighbor lifetime value. Use the no form of the command
to return to the default value.
ip dvmrp neighbor-timeout SECONDS
no ip dvmrp neighbor-timeout
Parameters
SECONDS
Default
By default, this value is 35 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If the router has not received a probe message from a neighbor after the neighbor timeout interval, the
neighbor is supposed to be down.
Example
This example shows how to configure the neighbor expiry time to 60 seconds for an interface.
value of 32 means infinity (unreachable).
Specifies the neighbor lifetime value. It can be a value from 1 to 65535
seconds.
417