D-Link DXS-3600 Series Reference Manual page 868

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Usage Guideline
This command removes the specified OSPF area and its configuration, such as area default-cost, area
range, area stub, and area virtual-link.
Example
This example shows how to remove area 0.0.0.3 of OSPF process 1.
Switch# configure terminal
Switch(config)# ipv6 router ospf 1
Switch(config-rtr)# no area 0.0.0.3
Switch(config-rtr)#
72-18 passive-interface (IPv6)
This command is used to configure the specified network interface or all interfaces as the passive
interface. Use the no form of the command to restore it to the default.
passive-interface {default | INTERFACE-ID}
no passive-interface {default | INTERFACE-ID}
Parameters
INTERFACE-ID
default
Default
None.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If an interface is passive, the OSPF routing update packets are not sent nor received through the
specified interface.
Example
This example shows how to configure all interfaces as passive and activates VLAN 1.
Switch# configure terminal
Switch(config)# ipv6 router ospf 1
Switch(config-rtr)# passive-interface default
Switch(config-rtr)# no passive-interface vlan1
Switch(config-rtr)#
72-19 redistribute
Specifies the interface as passive interface.
(Optional) Specifies all the interfaces as passive interfaces.
868