D-Link DXS-3600 Series Reference Manual page 677

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no loopback-detection interval
Parameters
interval SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the interval at which LBD packets are sent to discover the loop
occurrence.
Example
This example shows how to configure the time interval to 20 seconds.
Switch# configure terminal
Switch(config)# loopback-detection interval 20
Switch(config)#
59-4 loopback-detection vlan
This command is used to configure the VLANs to be enabled for loop detection. Use no command to
return to the default settings.
loopback-detection vlan VLAN-LIST
no loopback-detection vlan VLAN-LIST
Parameters
VLAN-LIST
Default
By default, this option is enabled for all VLANs.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the interval in seconds at which CPT packets are
transmitted. The valid range is from 1 to 32767.
(Optional) Specifies the VLAN identification number, numbers, or
range of numbers to be matched. Enter one or more VLAN values
separated by commas or hyphens for a range list.
677