D-Link DXS-3600 Series Reference Manual page 859

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
72-5 auto-cost reference-bandwidth
This command is used to control the reference value IPv6 OSPF uses when calculating metrics for
interfaces. To return the reference value to its default, use the no form of this command.
auto-cost reference-bandwidth MBPS
no auto-cost reference-bandwidth
Parameters
MBPS
Default
By default, this value is 100Mbps.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to control the reference value IPv6 OSPF uses when calculating metrics for
interfaces.
Example
This example shows how to set the auto-cost reference bandwidth to 1000 Mbps.
Switch# configure terminal
Switch(config)# ipv6 router ospf 1000
Switch(config-rtr)# auto-cost reference-bandwidth 1000
Switch(config-rtr)#
72-6 clear ipv6 ospf process
This command is used to restart the OSPF state, based on the OSPF routing process ID.
clear ipv6 ospf [PROCESS-ID] process
Parameters
PROCESS-ID
Default
Specifies the bandwidth rate in Mbps. The range is from 1 to 4294967.
The default is 100.
(Optional) Specifies the internally used identification parameter for an
IPv6 OSPF routing process. It is locally assigned and can be any
positive integer. A unique value is assigned for each IPv6 OSPF
routing process.
859