D-Link DXS-3600 Series Reference Manual page 108

Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs Also See for DXS-3600 Series:
Table of Contents

Advertisement

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to set VLAN100, whose IP address will be used as the source IP address, for
sending RADIUS packets.
Switch#configure terminal
Switch(config)# ip radius source-interface vlan100
7-19 ip tacacs source-interface
This command is used to specify the interface whose IP address will be used as the source IP address
for sending TACACS packets. To revert to the default setting, use the no form of this command.
ip tacacs source-interface INTERFACE-ID
no ip tacacs source-interface
Parameters
INTERFACE_ID
Default
The IP address of the closest interface will be used.
Command Mode
Global Configuration Mode or Server Group Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command can be used to specify the interface whose IP address will be used as the source IP
address for sending TACACS packets. If the source interface is specified in both the global configuration
mode and group server configuration mode, the source interface specified in group server configuration
mode take precedence.
When the server is located at the Out-Of-Band Management Port, the user should specify the interface ID
of Out-Of-Band Management Port as the source interface in order to send the request packet to the
management port
Example
This example shows how to set VLAN100, whose IP address will be used as the source IP address, for
sending TACACS packets.
Switch#configure terminal
Switch(config)# ip tacacs source-interface vlan100
7-20 ip vrf forwarding (server-group)
This command is used to configure the VRF reference of an authentication, authorization, and accounting
(AAA) RADIUS or TACACS+ server group, use the ip vrf forwarding command in the server group
configuration mode. To enable server groups to use the global (default) routing table, use the no form of
this command.
Specifies the interface whose IP address will be used as the source IP
address for sending TACACS packets.
108

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxs-3600-32s

Table of Contents