D-Link DXS-3600 Series Reference Manual page 229

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the parameters of BGP.
Example
This example shows how to display the parameters of BGP.
Switch# show ip bgp parameters
BGP Global State
Version
BGP Router Identifier
Synchronization
Enforce First AS
Local AS Number
Scan Time
Hold Time
Keepalive Interval
Always Compare MED
Deterministics MED
Med Confed
Default Local Preference
AS Path Ignore
Compare Router ID
MED Missing as Worst
Compare Confederation Path
Fast External Failover
Aggregate Next Hop Check
Default IPv4 Unicast
Switch#
10-90 show ip bgp peer-group
This command is used to display information about the peer group of BGP.
show ip bgp [ipv4 unicast | vpnv4 {all | rd RD-VALUE | vrf VRF-NAME}] peer-group [PEER-
GROUP-NAME]
Parameters
ipv4 unicast
vpnv4
all
rd RD-VALUE
vrf VRF-NAME
: Enabled
: 4
: 20.1.1.1
: Disabled
: Disabled
: 1
: 60 Seconds
: 180 Seconds
: 60 Seconds
: Disabled
: Disabled
: Disabled
: 100
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled
: Disabled
: Enabled
(Optional) Specifies the IPv4 unicast address family.
(Optional) Specifies the VPNv4 unicast address family.
(Optional) Specifies to display all the VPNv4 peer-groups.
(Optional) Specifies to display the VPNv4 peer-groups that match the
specified RD.
(Optional) Specifies to display the VPNv4 peer-groups that match the
specified VRF. The length of VRF-NAME is 12 characters.
229