D-Link DXS-3600 Series Reference Manual page 943

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
show ip pim interface [dense-mode | sparse-mode | sparse-dense-mode] [INTERFACE-ID]
[detail]
Parameters
INTERFACE-ID
detail
dense-mode
sparse-mode
sparse-dense-mode
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display interface related information. If no interface is specified, the PIM information
for all applicable interfaces will be shown.
Example
This example shows how to display interface information.
Switch# show ip pim interface
p: passive, Nbr Cnt: Neighbor Count
Address
-------------- ---------- ------ --- ------- -------------- ----------
90.1.1.1
30.1.1.1
12.1.1.1
Total Entries: 3
Switch#
This example shows how to display interface information in detail.
Switch# show ip pim interface detail
vlan100
Address
PIM
Mode
Neighbor Count
(Optional) Specifies the interface which to display the interface
information. Only VLAN interface IDs are applicable.
(Optional) Specifies to display the interface information in detail.
(Optional) Specifies to display information only for PIM dense-mode
(Optional) Specifies to display information only for PIM sparse-mode
(Optional) Specifies to display information only for PIM sparse-dense-
mode
Interface Mode Nbr DR
Cnt Priorty
vlan100 SM(p) 0
vlan200 DM 1
vlan300 SM-DM 1
: 90.1.1.1
: Enabled
: Sparse
: 1
943
DR
1 90.1.1.1
0 0.0.0.0
0 0.0.0.0
Generation
ID
1645d8a00
3a5f93
37c693