D-Link DXS-3600 Series Reference Manual page 122

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
8-5 ip proxy-arp
This command is used to enable the proxy ARP option for an interface. Use the no command to revert to
the default setting.
ip proxy-arp
no ip proxy-arp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the proxy ARP state for an interface. When proxy ARP is enabled, the
system will respond to ARP requests for IP addresses within the local connected subnets. Proxy ARP can
be used in the network where hosts have no default gateway configured.
Example
This example shows how to enable proxy the ARP feature on the interface of VLAN 100.
Switch# configure terminal
Switch(config)# interface vlan100
Switch(config-if)# ip proxy-arp
Switch(config-if)#
8-6 ip local-proxy-arp
This command is used to enable the local proxy ARP feature on an interface. Use the no form of the
command to revert to the default setting.
ip local-proxy-arp
no ip local-proxy-arp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
122