Show Vlan Filter - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If no access-map name is specified, all VLAN access-map information will be displayed. If the user
enables the ACL hardware counter for an access-map, the counter will be displayed based on each sub-
map.
Example
This example shows how to display the VLAN access-map.
Switch# show vlan access-map
VLAN access-map vlan-map 10
match ip access list: stp_ip1(ID: 1888)
action: forward
VLAN access-map vlan-map 20
match mac access list:
action: redirect
Switch#
This example shows how to display the contents of the VLAN access-map if its hardware counter is
enabled.
Switch# show vlan access-map
VLAN access-map vlan-map 10
match ip access list: stp_ip1(ID: 1888)
action: forward
Counter enable on VLAN(s): 1-2
match count: 8541 packets
VLAN access-map vlan-map 20
match mac access list:
action: redirect
Counter enable on VLAN(s): 1-2
match count: 5647 packets
Switch#

4-24 show vlan filter

This command is used to display the VLAN filter configuration of VLAN interfaces.
show vlan filter [access-map MAP-NAME | vlan VLAN-ID]
Parameters
ext_mac(ID: 6995)
eth1/0/5
ext_mac(ID: 6995)
eth1/0/5
68