D-Link DXS-3600 Series Reference Manual page 564

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
eth1/0/6
eth1/0/7
eth1/0/8
Total Entries: 8
Switch#
45-10 show interfaces auto-negotiation
This command is used to display detailed auto-negotiation information of physical port interfaces.
show interfaces [INTERFACE-ID [,|-]] auto-negotiation
Parameters
auto-negotiation
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the auto-negotiation information.
Example
This example shows how to display auto-negotiation information.
Switch# show interfaces ethernet 1/1/1-1/1/2 auto-negotiation
eth1/1/1
Auto Negotiation: Disabled
eth1/1/2
Auto Negotiation: Enabled
Remote Signaling: Not detected
Configure Status: Configuring
Capability Bits: 10M_Half, 10M_Full, 100M_Half, 100M_Full, 1000M_Full
Capability Advertised Bits: 10M_Half, 10M_Full, 100M_Half, 100M_Full, 1000M_Full
Capability Received Bits: -
RemoteFaultAdvertised: Disabled
RemoteFaultReceived: NoError
0 0
0 0
0 0
Specifies to display detailed auto-negotiation information.
(Optional) Specifies the interface ID. If no interface is specified, the
auto-negotiation information on all physical port interfaces will be
displayed.
0
0
0
564