D-Link DXS-3600 Series Reference Manual page 701

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
IPV6-ADDRESS
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. The proxy reporting function only works
for MLDv1 traffic.
When the function proxy reporting is enabled, the received multiple MLD report or leave packets will be
integrated into one report before being sent to the router port. Proxy reporting source IP will be used as
source IP of the report, Zero IP address will be used when the proxy reporting source IP is not set.
Interface MAC will be used as source MAC of the report. If the VLAN has no IP address configured, then
system MAC will be used.
Example
This example shows how to enable MLD snooping proxy-reporting on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ipv6 mld snooping proxy-reporting
Switch(config-vlan)#
63-8 ipv6 mld snooping querier
This command is used to enable the MLD snooping querier on the switch. Use the no form of this
command to disable the MLD snooping querier function.
ipv6 mld snooping querier
no ipv6 mld snooping querier
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. The interface must have IPv6 address
assigned to start the querier. The system will return warning message if the VLAN has no IPv6 address. If
querier is enabled, but IPv6 address is removed, the querier will be stopped.
(Optional) Specifies the source IP address of proxy reporting.
701