D-Link DXS-3600 Series Reference Manual page 479

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to assign the APS channel VLAN for an ERP instance. The APS channel VLAN needs
to be assigned before an ERP instance can be set to operation state.
The specified APS channel VLAN needs to exist before the instance can be set to operation state.
If the APS channel VLAN is removed when the ERP instance is in operation, the ERP instance will enter
operational disabled state.
Each ERP instances should have a distinct APS channel VLAN.
The APS channel VLAN of a sub-ring instance is also the virtual channel of the sub-ring.
Example
This example shows how to configure the APS channel VLAN of the ERP instance 1 as VLAN 2.
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring2
Switch(config-erp)# exit
Switch(config)# ethernet ring g8032 ring1
Switch(config-erp)# sub-ring ring2
Switch(config)# ethernet ring g8032 ring2
Switch(config-erp)# port0 interface eth3/0/1
Switch(config-erp)# port1 none
Switch(config-erp)# instance 1
Switch(config-erp-instance)# r-aps channel-vlan 2
Switch(config-erp-instance)#
37-6 inclusion-list vlan-ids
This command is used to define a set of Virtual LAN (VLAN) IDs that are protected by the Ethernet ring
protection mechanism. To delete the set of VLAN IDs, use the no form of this command.
inclusion-list vlan-ids VLAN-ID [, | -]
no inclusion-list vlan-ids VLAN-ID [, | -]
Parameters
VLAN-ID
,
-
Default
None.
Specifies the VLAN ID of the service protected VLANs of the ERP
instance. The valid range from is1 to 4094.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
479