D-Link DXS-3600 Series Reference Manual page 193

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
10-57 neighbor soft-reconfiguration
This command is used to enable the storing of the route information update from the neighbor peer. Use
the no form of the command to disable the storing of the route update information.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} soft-reconfiguration inbound
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} soft-reconfiguration inbound
Parameters
IP-ADDRESS
PEER-GROUP-NAME
Default
By default, this option is disabled.
Command Mode
Router Configuration Mode.
Address Family Configuration (IPv4 unicast and VRF) Mode.
Command Default Level
Level: 12.
Usage Guideline
If a soft reset is applied to inbound sessions. The session will not be terminated, but the local inbound
routing table will be cleared and it needs to be rebuilt.
If soft reconfiguration inbound is disabled, then the local router will send the route refresh request to the
neighbor to ask for the route refresh. If soft reconfiguration inbound is enabled, then the routing table can
be rebuilt based on the stored route updates information. Enabling of the soft reconfiguration feature will
consume extra system resource to store the route.
The user can use the show ip bgp neighbors command to see whether the neighbor supports the route
refresh capability. If the neighbor supports the refresh capability, the inbound routing table can be rebuilt
by refresh of the routing information.
Example
This example shows how to enable the storing of route update information for the neighbor peer session
10.100.0.1 since the peer does not support route refresh function.
Switch(config-router)# neighbor 10.100.0.1 soft-reconfiguration inbound
Switch(config-router)#
10-58 neighbor soo
This command is used to configure the Site-of-Origin (SoO) value of a peer or a peer group. Use the no
form of this command to remove the SoO value configured.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} soo SOO-VALUE
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} soo
Specifies the IP address of the neighbor peer.
Specifies the name of the BGP peer group.
193