DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
2-16
show terminal width
Description
The command is used to display the configuration of current terminal width.
Format
show terminal width
Parameters
None.
Restrictions
None.
Example
To display the configuration of current terminal width:
DGS-3000-26TC:admin#show terminal width
Command: show terminal width
Global terminal width
Current terminal width
DGS-3000-26TC:admin#
2-17
config ports
Description
This commands is used to configure the Switch's port settings.
Format
config ports [<portlist> | all] {medium_type [fiber | copper]} {speed [auto | 10_half | 10_full |
100_half | 100_full | 1000_full {[master | slave]}] | flow_control [enable | disable] | learning
[enable | disable] | state [enable | disable] | mdix [auto | normal | cross] | [description <desc
1-32> | clear_description]}
Parameters
<portlist> - Enter a list of ports used here.
all - Specifies that all the ports will be used for this configuration.
medium_type - (Optional) Specifies the medium type while the configure ports are combo ports
fiber - Specifies that the medium type will be set to fiber.
copper - Specifies that the medium type will be set to copper.
speed - (Optional) Specifies the port speed of the specified ports .
auto - Sets port speed to auto negotiation.
10_half - Sets port speed to 10_half.
: 80
: 80
19