Show Ip Igmp Interface - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Expires
Group mode
Last reporter
46-13

show ip igmp interface

This command is used to display IGMP configuration information on an interface.
show ip igmp interface [INTERFACE-ID]
Parameters
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display IGMP configuration settings on interfaces.
Example
This example shows how to display IGMP configuration information about interface VLAN 1000.
Switch# show ip igmp interface vlan1000
VLAN 1000
Version
IP Address/Netmask
IGMP State
Querier
Query Interval
Query Maximum Response Time : 10 seconds
Robustness Variable
Last Member Query Interval
[n]DT[n]H[n]M[n]S.
The time that the entry will be removed if there is no refresh on the
entry in the format of [n]DT[n]H[n]M[n]S.
Stopped indicates that timing out of this entry is not determined by this
expire timer. If the router is in Include mode for a group, then the whole
group entry times out after the last source entry has timed out (unless
the mode is changed to Exclude mode before it times out).
Include or Exclude: The group mode is based on the type of
membership reports that are received on the interface for the group.
The last host to report being a member of the multicast group.
(Optional) Specifies a single interface, a range of interface separated
by a hyphen, or a series of interface separated by a comma. If no
interface is specified, the switch displays IGMP information on all
interfaces on which IGMP is enabled. Note that only VLAN interfaces
can be specified.
: 3
: 10.50.95.90/8
: Enabled
: 10.50.95.90
: 125 seconds
: 3
: 2 seconds
576