D-Link DXS-3600 Series Reference Manual page 275

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
CFM MA Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create an MEP ID list in a maintenance association. To add an MEP ID into the
list, use the cfm mepid-list add command. To delete an MEP ID from the list, use the cfm mepid-list
delete command. Before defining an MEP, the MEP ID list must be created and the MEP's ID must be
added into the list.
Example
This example shows how to create an MEP ID list and add the MEP IDs 1 and 2 into it for a maintenance
association.
Switch# configure terminal
Switch(config)# cfm domain op-domain level 2
Switch(config-cfm-md)# cfm ma name op1 vlan 2
Switch(config-cfm-ma)# mepid-list add 1,2
Switch(config-cfm-ma)#
14-19 mip creation (cfm md configuration)
This command is used to configure the default MIP creation in a maintenance domain. To reset the
configuration of the MIP creation to the default setting, use no command.
mip creation {none | auto | explicit}
no mip creation
Parameters
none
auto
explicit
Default
By default, this option is none.
Command Mode
CFM MD Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies not to create the MIP for a maintenance domain.
Specifies that MIPs will always be created on any port in this
maintenance domain, if that port is not configured as an MEP of this
maintenance domain. For an intermediate switch in an MA, the setting
must be automatically in order for the MIPs to be created on this
device.
Specifies that MIPs can be created on ports that has an existing lower
level MEP configured on it and that the port is not configured as an
MEP of this maintenance domain.
275