D-Link DXS-3600 Series Reference Manual page 453

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
ets recommend {bandwidth WEIGHT0 WEIGHT1 WEIGHT2 WEIGHT3 WEIGHT4 WEIGHT5
WEIGHT6 WEIGHT7 | cos-map COS-QUEUE COS-VALUE [, | -]}
no ets recommend [bandwidth | cos-map]
Parameters
bandwidth WEIGHT0
WEIGHT2 WEIGHT3 WEIGHT4
WEIGHT5 WEIGHT6 WEIGHT7
cos-map COS-QUEUE COS-
VALUE [, | -]
Default
The recommended bandwidth is 4, 7, 11, 14, 18, 21, and 25 (in percentage) for traffic classes 0 to 6
respectively. 0 for traffic class 7 means the recommended transmission selection algorithm is "strict
priority.
The default priority (CoS) to traffic class mapping is 0 to 1, 1 to 0, 2 to 2, 3 to 3, 4 to 4, 5 to 5, 6 to 6, and
7 to 7.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the recommended bandwidth (in percent) for each traffic class. The value of
zero means using "strict priority" for the corresponding traffic class. If the no ets recommand command
is issued without any keywords, all ETS recommendation settings (bandwidth and priority assignments)
will be reverted to the default values.
Example
This example shows how to configure the recommended transmission selection algorithm for traffic
classes 0 to 4 is ETS and the allocated bandwidth is 10%, 10%, 20%, 20%, and 40% respectively. For
traffic class 5 to 7 the recommended transmission selection algorithm is strict priority.
Switch# configure terminal
Switch(config)# interface eth3.1
Switch(config-if)# ets recommend bandwidth 10 10 20 20 40 0 0 0
Switch(config-if)#
34-3 show ets interface
This command is used to display the ETS information of a given interface or all interfaces.
Specifies the recommended bandwidth for traffic classes 0 to 7. It is
required to specify 8 values for traffic class 0 to 7 respectively. The
sum of the bandwidth assigned to a given port is required at all times
to be equal to 100. An operation that attempts to change the
bandwidth where the sum is not 100 will be rejected. The valid range is
from 0 to 100 (in percentage). The value of zero stands for strict
priority mode.
Specifies the recommended priority assignment table.
COS-QUEUE: Specifies the queue ID (Traffic Class) for the specified
priority.
COS-VALUE: Specifies the priority to be mapped. The value is from 0
to 7.You can specify multiple priorities queued into the specified traffic
class.
453