D-Link DXS-3600 Series Reference Manual page 818

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
By default, this value is 1.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The OSPF router will determine a designated router for the multi-access network.
This command sets the priority used to determine the OSPF Designated Router (DR) for a network. If two
routers attempt to become the DR, the router with the higher router priority will be elected the DR. If the
routers have the same priority, the router with the higher router ID takes precedence.
Only routers with non-zero router priority values are eligible to become the designated or backup
designated router.
Example
This example shows how to configure the OSPF priority value to 3 on the VLAN 1 interface.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ip ospf priority 3
Switch(config-if)#
71-19 network area
This command is used to enable OSPF routing with the specified area ID on interfaces with IP addresses
that match or belong to the specified network address. Use the no command to remove the configuration.
network NETWORK-PREFIX NETWORK-MASK area AREA-ID
no network NETWORK-PREFIX NETWORK-MASK area AREA-ID
Parameters
NETWORK-PREFIX
NETWORK-MASK
AREA-ID
Default
None.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to create an OSPF area on the interfaces. The area will be created on an interface if
the subnet configured on the interface falls in the range of the network specified by the command. The
Specifies the subnet prefix and subnet mask of the network.
Specifies the identifier of the area to be created.
818