D-Link DXS-3600 Series Reference Manual page 272

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
This command is used to delete the stored link-trace response data that has been initiated by the
specified MEP.
Example
This example shows how to delete received link-trace responses.
Switch# clear cfm linktrace mepid 1 ma name op-ma1 domain op-domain1
Switch#
14-15 clear cfm pkt-cnt interface
This command is used to clear the CFM packet's RX/TX counters of the specified physical interface.
clear cfm pkt-cnt interface {INTERFACE-ID [, | -] | all} [rx] [tx]
Parameters
INTERFACE-ID
,
-
rx
tx
all
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to clear the physical interface's packet counters. If only the physical interface is
specified, it will clear both the RX and TX packet counters of the specified physical interface. If both the
physical interface and the RX/TX type is specified, it will clear the RX or TX packet counters of the
specified physical interface.
Example
This example shows how to clear TX packet counters of eth 1/0/1.
Switch# clear cfm pkt-cnt interface eth1/0/1 tx
Specifies the interface ID to clear. The allowed interfaces only include
physical interfaces.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and after
the hyphen.
(Optional) Specifies the RX counters of the specified physical
interface.
(Optional) Specifies the TX counters of the specified physical interface.
Specifies to clear all interface's CFM counters.
272