Loopback Detection (Lbd) Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

59. Loopback Detection (LBD) Commands

59-1 loopback-detection (Global)
This command is used to enable the loopback detection function globally. Use the no form of the
command to disable the function globally.
loopback-detection [mode {port-based | vlan-based}]
no loopback-detection [mode]
Parameters
mode
port-based
vlan-based
Default
By default, this option is disabled.
By default, the detection mode is port-based.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Generally, port-based loop detection is used in ports that are connected to users, and VLAN-based
detection is used in trunk ports when the partner switch does not support the loop detection function.
When doing port-based detection, the LBD enabled port will send untagged port-based LBD packets out
from the port to discover the loop. If there is a loop occurrence on the path, then the packet being
transmitted will loop back to the same port or to another port located on the same device. When an LBD
enabled port detects a loop condition, packet transmitting and receiving is disabled at the port.
When doing VLAN-based detection, the port will periodically send VLAN-based LBD packets for each
VLAN that the port has membership of the VLAN is enabled for loop detection. If the port is a tagged
member of the detecting VLAN, tagged LBD packets are sent. If the port is an untagged member of the
detecting VLAN, untagged LBD packets are sent. If there is a loop occurrence on the VLAN path, then
packet transmitting and receiving will be temporarily stopped on the looping VLAN at the port where the
loop is detected.
If an LBD disabled port receives an LBD packet and detects that the packet is sent out by the system
itself, the sending port will be blocked if the packet is a port-based LBD packet, or the VLAN of the
sending port will be blocked if the packet is a VLAN-based LBD packet.
If the port is configured for VLAN-based and if the port is an untagged member of multiple VLANs, then
the port will send one untagged LBD packet for each VLAN with the VLAN number specified in the VLAN
field of the packet.
There are two ways to recover an error disabled port. The user can use the errdisable recovery cause
loopback-detect command to enable the auto-recovery of ports that were disabled by loopback detection.
Alternatively, manually recover the port by entering the shutdown command followed by the no
shutdown command for the port.
(Optional) Specifies the detection mode.
Specifies that the loop detection will work in the port-based mode.
Specifies that the loop detection will work in the VLAN-based mode.
675