D-Link DXS-3600 Series Reference Manual page 398

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
This command enables DHCP for IPv6 server service on a specified interface.
An IPv6 DHCP pool can be associated with multiple interfaces. The pool must be configured before it can
be associated. Only one IPv6 DHCP pool can be associated with an interface. The DHCP for the IPv6
client, server, and relay functions are mutually exclusive on an interface.
If the command is configured with the rapid-commit option, the server will proceed the two-message
exchange for prefix delegation and other configuration if the client has included a rapid commit option in
the solicit message.
Example
This example shows how to create the DHCP pool "pool1", enable the DHCP IPv6 server service on the
interface VLAN 100 using the DHCP pool "pool1" to delegate the prefixes.
Switch# configure terminal
Switch(config)# ipv6 dhcp pool pool1
Switch(config-dhcp)# exit
Switch(config)# interface vlan100
Switch(config-if)# ipv6 dhcp server pool1
Switch(config-if)#
26-9 ipv6 local pool
This command is used to configure a local IPv6 prefix pool. Use the no form to remove the pool.
ipv6 local pool POOL-NAME IPV6-PREFIX/PREFIX-LENGTH ASSIGNED-LENGTH
no ipv6 local pool POOL-NAME
Parameters
POOL-NAME
IPV6-PREFIX
PREFIX-LENGTH
ASSIGNED-LENGTH
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the name of the local IPv6 prefix pool with a maximum of 32
characters.
Specifies the IPv6 prefix address of the local pool.
Specifies the IPv6 prefix length of the local pool.
Specifies the prefix length to delegate to the user from the pool. The
value of the assigned length cannot be less than the value of the prefix
length.
398